kasirajang
Newbie level 5
In ASIC devices, why the impedance is varying if you reverse the polarity of the multimeter while measuing the impedance between signal pin/power pin with Ground pin.
Welcome to EDAboard.com
Welcome to our site! EDAboard.com is an international Electronic Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
why impedance is varying in with polarity of the multimeter?
- Thread starter kasirajang
- Start date
- Status
avimit
Banned
Re: why impedance is varying in with polarity of the multime
it may have to do with pn or np junctions inside your device(IC) geting reverse bias or fwd bias, when you change the polarity.
Kr,
Avi
http://www.vlsiip.com
it may have to do with pn or np junctions inside your device(IC) geting reverse bias or fwd bias, when you change the polarity.
Kr,
Avi
http://www.vlsiip.com
- Status
Similar threads
