Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
u6 is a not gate for drivering RF switch u1,it is a GaAs SPDT Switch with less than 5 ns switch speed
so whats r15 r16 c19 c20 used for?
thank you for your help
I do not know the drive specifications of the U1 MMIC. The c19 and c20 are needed to prevent RF to propagate where it should not, the resistors are for the same purpose as well to limit the control current from TTL drive to the driven MMIC ports.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
