Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Electromigration, is it due a high current during a long time, which will move physically the metal, up to open the power net.
To solve that, made a good flooplan which well design power nets structure.
Some one used the metal filling connected to power nets (for example odd layer to ground and even layer to supply) to reduce the resistivity and then reduce the EM, this is after the routing/si steps.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
