BGA
Advanced Member level 4
I'm trying to export placement coordinates of my board with the command under:
file/export/general interfaces/Generic ATE.
When the operation start, I receive an error from:
AppName: vbcam_tl.exe AppVer: 16.1.1.1 ModName: vbcam_tl.exe
ModVer: 16.1.1.1 Offset: 0000369d.
This is the report:
Expedition PCB General Interfaces
---------------------------------
01:34 AM Friday, June 06, 2003
Job Name: C:\Documenti\Board\PCB\board.pcb
Processing Setup Parameters
Processing Padstack Definitions
Processing PadStack Pads
Processing PadStack Definitions
Processing Cell Library
Any help?
Thanks in advance.
file/export/general interfaces/Generic ATE.
When the operation start, I receive an error from:
AppName: vbcam_tl.exe AppVer: 16.1.1.1 ModName: vbcam_tl.exe
ModVer: 16.1.1.1 Offset: 0000369d.
This is the report:
Expedition PCB General Interfaces
---------------------------------
01:34 AM Friday, June 06, 2003
Job Name: C:\Documenti\Board\PCB\board.pcb
Processing Setup Parameters
Processing Padstack Definitions
Processing PadStack Pads
Processing PadStack Definitions
Processing Cell Library
Any help?
Thanks in advance.