Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

waveguide components

Status
Not open for further replies.

microwaveeng

Newbie level 1
Joined
Jan 19, 2013
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,287
I want to construct a curved line with a WR90 waveguide (L=1m)
what is best and accurate procesure of Manufactureing it?
can ant one help with a refrence
 

Find a book by MOreno: MIcrowave component design,or Harvey: MIcrowave Engineering.

Use the largest curvature radius, or be ready to include correction stub or iris to compensate.
 

You can fill it full of sand, ice, or other incompressible material and bend it on a mandrel. Then you pour out the material and the cross-section has not collapsed on you.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top