Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[SOLVED] watching slew rate in folded cascade simulation

Status
Not open for further replies.
A

A.jafari

Member level 1
Joined
Apr 9, 2011
Messages
34
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Location
Iran
Activity points
1,491
Hi.
I designed a folded cascade Opamp with Hspice and I want to know that how can I simulate slew rate with Hspice ?
could you show a schematic about your answer?
with best wishes :wink:
A.Jafari
 
Last edited:

check up allen holdberg chapter 6 simulation and measurement of op amps....
To measure slew rate, connect the opamp in voltage follower config and measure the slope of the transient response for a capacitive load...
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top