Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronic Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Vxworks: Two Ethernet Port Configuration

Status
Not open for further replies.

kiran81077

Member level 1
Joined
Feb 10, 2007
Messages
38
Helped
3
Reputation
8
Reaction score
0
Trophy points
1,288
Activity points
1,526
vxworks ethernet port config

Hi All,

I have a Single Board Computer running Vxworks 5.5.1 which has two
ethernet controllers (gteth) type. One device gets initialized at the
boot stage. Once VxWorks is running, am trying to add the second
device using the functions ipAttach, ifMaskSet, ifAddrSet. I am able
to add the second device into a different subnet mask but not the same
one as the first ethernet device.

My requirement is to set one ethernet controller to IP address
192.168.50.1 and the other to 192.168.50.2.

Have anybody come across this type of issue. If else request you to
provide some pointers to fulfill the requirement.

Thanks in advance,

Kiran
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top