kiran81077
Member level 1
vxworks ethernet port config
Hi All,
I have a Single Board Computer running Vxworks 5.5.1 which has two
ethernet controllers (gteth) type. One device gets initialized at the
boot stage. Once VxWorks is running, am trying to add the second
device using the functions ipAttach, ifMaskSet, ifAddrSet. I am able
to add the second device into a different subnet mask but not the same
one as the first ethernet device.
My requirement is to set one ethernet controller to IP address
192.168.50.1 and the other to 192.168.50.2.
Have anybody come across this type of issue. If else request you to
provide some pointers to fulfill the requirement.
Thanks in advance,
Kiran
Hi All,
I have a Single Board Computer running Vxworks 5.5.1 which has two
ethernet controllers (gteth) type. One device gets initialized at the
boot stage. Once VxWorks is running, am trying to add the second
device using the functions ipAttach, ifMaskSet, ifAddrSet. I am able
to add the second device into a different subnet mask but not the same
one as the first ethernet device.
My requirement is to set one ethernet controller to IP address
192.168.50.1 and the other to 192.168.50.2.
Have anybody come across this type of issue. If else request you to
provide some pointers to fulfill the requirement.
Thanks in advance,
Kiran