voice controlled vehicle

[adityabvmk]

i want to interface rf transmitter to 8051 and then send only some of the required words to the receiver...then compare those words in receiver side and correspondingly move the motor according to instructions received....the block diagram is as shown in the attachment.....

 

[ckshivaram]

You plan to do a voice controlled robot, i used VB software to speak the command through microphone and send the data through RF, and move the robot, shoot the bullets, dance, etc............. Is it the same thing you are going to do it.....

What is that you have done till now... i cant share the code as i lost it.... i have the RF and 8 bit controller code... but i can guide you in this...........

 

[adityabvmk]

yes i want to do the same....thank u for ur reply....please share the rf and 8 bit controller code.....

---------- Post added at 23:46 ---------- Previous post was at 23:43 ----------

also help me in doing this......

 

[ckshivaram]

check this 100% tested code........

 

[harishwww]

check this 100% tested code........

sir can you help on making circuit diagram

 

[mishra12]

try to read code every thing is there

---------- Post added at 06:27 ---------- Previous post was at 06:26 ----------

sir can you help on making circuit diagram

try to read code every thing is there

 

[adityabvmk]

will u please provide the interfacing schematic of 89c51 and rf transmitter and rf receiver so that i can implement that on a pcb....

 

[ckshivaram]

transmitter


receiver

 

[adityabvmk]

thank u....what about the transmitter..both are receiver circuits only....

 

[ckshivaram]