Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
have not tried it yet, but if you can firmly attach it to what you want to measure, without adding ANY low frequency test board resonances, it should work! I would be tempted to solder that chip to a very small pcb, with flexible magnet wires running off of the board. I would glue the chip to the pcb, and glue the top of the chip to the device I wanted to test.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
