Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronic Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[SOLVED] Using Remote ON/Off in Traco power DC/DC converter

Status
Not open for further replies.

AWahab

Junior Member level 1
Joined
Oct 2, 2013
Messages
16
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Location
Pakistan
Activity points
115
Hello,

can anyone tell me how to use Remote on/off pin in traco power DC/DC converters? :bang:

Regards,
AW
 

hobbyckts

Advanced Member level 1
Joined
Mar 12, 2015
Messages
481
Helped
88
Reputation
176
Reaction score
85
Trophy points
28
Activity points
2,457
Generally it is about switching off the output supply by making it high or low whichever is mentioned in the datasheet. What is the which you are asking for?
 
  • Like
Reactions: AWahab

    AWahab

    points: 2
    Helpful Answer Positive Rating

AWahab

Junior Member level 1
Joined
Oct 2, 2013
Messages
16
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Location
Pakistan
Activity points
115
Thanks hobbyckts.

I am using THN 15-1221 with 12V power. Its +-5V dual voltage regulator. I just want it to run it all the time. Can I connect it directly with 12V power supply?

The reason not to switch is because I will install the switching ckt for +5V and -5V independendently and this regulator gives me the possibilty of on/off both +-5V with the single input.
 

KlausST

Super Moderator
Staff member
Joined
Apr 17, 2014
Messages
18,076
Helped
4,053
Reputation
8,106
Reaction score
3,968
Trophy points
113
Activity points
119,284
Hi,

reading the datasheet gives that information within 10 seconds (inclusive google search, download and opening PDF):

Code:
Remote On/Off 
– On: 3.0 ... 15 VDC or open circuit
– Off: 0 ... 1.2 VDC or short circuit pin 6 and pin 2
– Off idle current: 2.5 mA
What else do you need?


Klaus
 
  • Like
Reactions: AWahab

    AWahab

    points: 2
    Helpful Answer Positive Rating

hobbyckts

Advanced Member level 1
Joined
Mar 12, 2015
Messages
481
Helped
88
Reputation
176
Reaction score
85
Trophy points
28
Activity points
2,457
Connect the pin to ground if you don't want to use it.. It is mentioned in the datasheet itself..But anyway all the best
 
  • Like
Reactions: AWahab

    AWahab

    points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.
Toggle Sidebar

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top