Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

USB socket for programmer

Status
Not open for further replies.
W

wakaka

Full Member level 4
Joined
Dec 7, 2005
Messages
237
Helped
10
Reputation
20
Reaction score
6
Trophy points
1,298
Activity points
2,931
**broken link removed**

currently I'm trying to draw a pcb for usb programmer, and i'm using the usb socket which is on the rite (dunno wats the name). The problem is i dunno which pin number 1(vcc), 2 (d-), 3 (d+), 4 (Gnd). plz help, thanx
 

I think it is not very difficult
You can use a von meter to measure it
as I know
pin 1 is VCC an pin 4 is GND you can test by mean of mesuring
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top