Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

usb device cable is unrecognized by pc

Status
Not open for further replies.
S

summer5

Newbie level 3
Joined
Jan 20, 2010
Messages
4
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,317
hello everyone,

my project requires me to use both usb blaster cable and usb device cable.

when i program my project using programmer in Quartus II,everything is ok.

However, once I run my firmware program at Nios II as Nios II hardware, then my usb device cable becomes unrecognized by my PC immediately.

Does anyone know to fix this problem?
Any suggestion will be very much appreciated. :)

Thanks,
Summer
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top