Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
you have done wrong in this design.
you have made a ground plane under the dielectric but in CPW antenna there should be no ground under the substrate. Ground plane is use to be present on the both side of the microstrip line. In your design the rectangle 3 and rectangle 4 should be the ground plane and these ground plane should be conduct by excite them.
i tried to do correction in your design and i have assign the port in your design.just have a look on this an dtry to understand that how i assign the port
i hope it will helpful for you
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.