Urgent!Please help!feed of print meander line antenna

Status
Not open for further replies.
X

xuanmogao

Newbie level 3
Joined
Mar 29, 2012
Messages
3
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,309
I have been simulated printed meander line antenna, according to the attached file.
But I do not understand the paper. It only shows the top side of the antenna. What is the back side of the antenna?
I simulated using figure 1. I can make it resonate at around 2.5 GHz, but the return loss is about -4db too high.
Ｉ　ｔｈｉｎｋ　Ｉ　ｍａｙ　ｄｏｎｅ　ｓｏｍｅｔｈｉｎｇ　ｗｒｏｎｇ．　Ｂｕｔ　Ｉ　ｄｏｎ＇ｔ　ｋｎｏｗ　ｗｈｅｒｅ　ｉｓ　ｔｈｅ　ｐｒｏｂｌｅｍ．
Ａｌｓｏ，　ｔｈｅｒｅ　ｉｓ　ａ　ｈｏｌｌｏｗ　ａｒｒｏｗ　ａｎｄ　ｄｏｔｔｅｄ　ｌｉｎｅ　ｉｎ　ｆｉｇｕｒｅ　１．　Ｗｈａｔ　ｄｏｅｓ　ｔｈｅｍ　ｓｔａｎｄ　ｆｏｒ？　Ｈｏｗ　ｃａｎ　Ｉ　ｆｅｅｄ　ｔｈｅ　ａｎｔｅｎｎａ？
Ｔｈａｎｋｓ　ａ　ｍｉｌｌｉｏｎ！
 

Attachments

  • the_effect_of_conductor_line_to_meander_line_antenna_design_5098.pdf
    207.6 KB · Views: 173

The other side is a whole sheet of metal covering the whole substrate (the ground)

it is a microstrip fed antenna and the other side must be the metalic gound plane I think
 

Thank you flashking! I simulated now as you said. The return loss at 2.4GHz is now around -10dB still too low. The paper said it should be -39dB. And my radiation pattern did not seem right. I attached my hfss file here.
Please!!! Could anyone help me to see where I was wrong? Thanks a million!!!
 

Attachments

  • meander1.rar
    19.8 KB · Views: 92

I viewed the figure fast

a small notice, I didn't see integration line for the lumped port

also you can try the waveguide port instead

finally, did you simulate with a lossy or a lossless FR4 Substrate ?
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…