Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Unable to read frequincy from signal generator on Fluke 1911A

Status
Not open for further replies.
P

Petege

Newbie level 1
Joined
Oct 20, 2010
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,287
Hi,
I have a Fluke 1911A Multi-Counter and a Ramsey SG560 Audio Generator. I'd like to read the frequency from the signal generator on the 1911A. I've tried every setting on the Fluke but it only reads zeros. Does the signal need to be amplified before sending to the Fluke? What do I need to do? Thanks
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top