Hi I want to extract Layout of a DTMOS(ST45 nm). On DTMOS bulk is conected to Gate.
To isolate the bulk (Pwell) on a Nmos I am using DNW to provide vertical isolation and an Nwell guard ring to get a lateral isolation as figures depicted.
The main purpose of this is to get two isolated Pwell on the same DNW (it can be done, i checked on rule book).
The problem is that I am not able to pass the LVS test due to SCONNECT conflicts detected.
Sure, why not? They should just have enough spacing, as not to risk BJT/SCR action between them.
An n+ guard ring connected to VDD (as tap of the Nwell resp. DNW) around the p-well should ensure this.
Sure, why not? They should just have enough spacing, as not to risk BJT/SCR action between them.
An n+ guard ring connected to VDD (as tap of the Nwell resp. DNW) around the p-well should ensure this.
ThankS Erikl .
May I avoid the n+ guard ring? This leads to a very large area occupancy due to the minimum area needed to the guard ring and to the distance needed beetwen two n+ guard ring. If i Connect deep nwell to vdd and use enough space (as explained by foundry rules) i think i generate two isolated Pwell (completely isolated one respect to the other ). Is it right?
I wouldn't actually risk to totally avoid it. If you really have to save this space, I'd draw at least an n+ guard line between the two pmos wells - at least if these are at different potential. You need an n+tap anyway, so it could well be between the two p-regions. That's a compromise between area saving and latch up risk prevention.