Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[AVR] tried to program atmega8 using extreme burner...but got error

Status
Not open for further replies.
D

Deexith Hasan

Advanced Member level 4
Full Member level 1
Joined
Oct 24, 2014
Messages
111
Helped
4
Reputation
8
Reaction score
3
Trophy points
18
Activity points
740
tried to program atmega8 using extreme burner...but got error i'm using USBASP v2.0

installed dribers correctly and seen usbasp in device manager...miso,mosi,vcc,reset,gnd connection are made clear but

simple blink program while burning got..
error
"power turned on..
power turning on failed...." in extreme burner

y how to solve this problem...
i measured vcc and gnd its 5v
 

why i'm getting this error whats the solution i rechecked my connection..
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top