Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Triangular wave removing DC offset

Status
Not open for further replies.

themaccabee

Full Member level 4
Joined
Apr 1, 2007
Messages
201
Helped
6
Reputation
12
Reaction score
6
Trophy points
1,298
Activity points
3,003
Hi,

I ve got a triangular wave having some DC content..can someone tell me how to remove this dc content so that my triangular wave starts from 0V.
 

themaccabee

Full Member level 4
Joined
Apr 1, 2007
Messages
201
Helped
6
Reputation
12
Reaction score
6
Trophy points
1,298
Activity points
3,003
Can you tell me how to design it properly??
 

kak111

Advanced Member level 4
Joined
Mar 30, 2011
Messages
1,366
Helped
933
Reputation
1,868
Reaction score
907
Trophy points
1,413
Location
Finland
Activity points
10,942
If you connect series capasitor to triangular wave , you get +/- symmetrical wave to gnd.
If you need wave from zero to +Vpp, you must make bias circuit for adjusting offset -Vpp to gnd.
 

IanP

Advanced Member level 5
Joined
Oct 5, 2004
Messages
7,942
Helped
2,309
Reputation
4,620
Reaction score
531
Trophy points
1,393
Location
West Coast
Activity points
66,459
Can you tell me how to design it properly??

If you assume that the output impedance of the source of the signal is negligible low, you need to find out the input impedance of the load (or the next stage) ..
Once you determine it you can calculate the value of the coupling capacitor in the terms of 3dB frequency, or just use the web-available calculator:
Coupling Capacitor Calculator by V-Cap

:wink:
IanP
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top