transferring data from android phone to AT-Mega16 through AUBTM 20 bluetooth

[abhaya.vin]

HI all,
can anyone please tell me how to transfer the data from aubtm 20 serially i am not able to run the AT+BPROFILE command, I write AT+BPROFILE= it instantaneously Give OK and again when i give this command AT+BPROFILE=? it gives error.

I am not able to enter SSP mode i need the solution urgently my deadline is this weekend. Please help. Thank you.

 

[mishra12]

connect it to serial port using max 232 first and see the result

 

[abhaya.vin]

I have this max 232 chip on the blutooth module itself I am able to run AT commands on the tera terminal. but i am not able to select the spp profile by using AT+BPROFILE command.

 

[mishra12]

Goto setting mode by typing LLL on hyperterminal

(connect suitable port as used by FTDI chip and 9600,8,1,0 settings

also enable local echo and CR+LF)



Try following commands



AT?

AT+MODE=19200,8,1,0

AT+NAME=abhaya.vin

---------- Post added at 19:37 ---------- Previous post was at 19:36 ----------

Goto setting mode by typing LLL on hyperterminal

(connect suitable port as used by FTDI chip and 9600,8,1,0 settings

also enable local echo and CR+LF)



Try following commands



AT?

AT+MODE=19200,8,1,0

AT+NAME=abhaya.vin

---------- Post added at 19:39 ---------- Previous post was at 19:37 ----------

did you receive any data on terminal ?

---------- Post added at 19:40 ---------- Previous post was at 19:39 ----------

did you receive any data on terminal ?

---------- Post added at 19:44 ---------- Previous post was at 19:40 ----------

just open terminal and set new connection don't need to select spp first send any dat to bluetooth modem adjust baud rate to synchronize with your mobile code if it receives data must show on window first try to do this then go to at command