Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

to put the location of component from CST-DS to CST_MW

Status
Not open for further replies.
A

azhana

Newbie level 4
Joined
Dec 8, 2009
Messages
6
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,315
i want to fabricate the low noise amplifier circuit. i had design the circuit by using CST-design studio. after finish simulating and get the parameters value of low noise amplifier, i would like to transform it at fr4 material. so that, i must locate the dimension of each component in the board of fr4 fabricating material. So the question is, how to transform it...is that any standard dimension for the component. i prefer to use chip component. here i attach the circuit design by using CST-DS.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top