Nissan23
Newbie
Hi! First post here.
I have a question regarding a(ny) CAN transceiver. Take TJA1050 as an example;
If just powering the board up with nothing connected on Tx or Rx pins , what will be seen on CAN H/L Pins? I assume nothing?….
My goal is to find a module, such as when just being powered up, some CAN messages will be transmitted on the bus.
To explain, I work as a automotive trainer, and since I don’t know how to manipulate a module to send corrupted messages, I want to simulate a vehicle module being faulty when powered up by power up a separate module (TJA1050?) at the same, provided this module will create a disturbance on the bus.
Any suggestions how to simulate this fault?
Thanks.
I have a question regarding a(ny) CAN transceiver. Take TJA1050 as an example;
If just powering the board up with nothing connected on Tx or Rx pins , what will be seen on CAN H/L Pins? I assume nothing?….
My goal is to find a module, such as when just being powered up, some CAN messages will be transmitted on the bus.
To explain, I work as a automotive trainer, and since I don’t know how to manipulate a module to send corrupted messages, I want to simulate a vehicle module being faulty when powered up by power up a separate module (TJA1050?) at the same, provided this module will create a disturbance on the bus.
Any suggestions how to simulate this fault?
Thanks.