Or you can also simulate the noise sources in your circuit, which resembles the operation of a real circuit the most. Startup time may be longer, but is would also be in real life!
Or you can also simulate the noise sources in your circuit, which resembles the operation of a real circuit the most. Startup time may be longer, but is would also be in real life!
1. How could I simulate the noise source in Cadence?
2. How should I config the options(conservative, moderate or liberal and etc) when I run transient simulation in Cadence to check the start-up period?
The start-up periods are different with different transient simulation configurations. Is "conservative" more accurate?
I have designd a crystal oscillator and modeling it with LRC in series. To simulate
the startup by adding the initial current which represent the original energy in the inductor. so I think you can try it