the initial I/O state when Spartan 2 is power up

Status
Not open for further replies.
E

EDA_hg81

Advanced Member level 2
Joined
Nov 25, 2005
Messages
507
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,298
Activity points
4,808
When the Spartan 2 is powered up, the I/O state is low or high? I didn’t find any pin such as one on Spartan 3 to control the initial I/O state.

I want the initial I/O state of Spartan 2 to be all low when it is powered up, how I can do this?

Thank you for your any suggestions.
 

Hello,

You can use an external pulldown 4.7 kOhm resistor. your device packge pins should be "wide" enough so that you can connet a resistor to the ground plane.

Bets Wishes,
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…