tetramax, z3
Hi Daman ,
I tried doing trouble shooting and got some hints about how
to remove this error. There can be three different ways of
handling this:
1) By Ignoring this error using the cmd "set Rules <errorID> Ignore. I tried doing this also, but end up with Scan Blocking Rule violation.
2) By initializing the Primary Input constraint in such that
the contention can be overcome. This process seems
tough one. I gues the changes has to be made in Protocol
file( may be in test_setup macro)
3) By modifying the circuit itself.
It seems for me these are as tedious process, I want
some suggestion in overcoming this in quicker way.
Thanks for your response.
With Regards,
JaY
Added after 2 hours 52 minutes:
Some how I got success in resolving the Z3 violation. I did some
modification in source netlist file. It was some what intuitive trial.
I will post the details.
" Intuition always leads over the Logic "