Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Test Crystal Oscillator & Microcontroller

Status
Not open for further replies.
A

aandavan

Advanced Member level 4
Full Member level 1
Joined
Aug 31, 2006
Messages
104
Helped
8
Reputation
16
Reaction score
7
Trophy points
1,298
Location
india
Visit site
Activity points
1,918
Hi,
How to test my crystal oscillator working condition. Also suggest me ideas to test the micro-controller working condition (hardware based testing, not by programming the micro-controller).
 

http://www.electronicrepairguide.com/how-to-test-crystal.html

to test the micro controller with out program is you might check its VCC and GND pin is not sorts or any other pins are not shorts but for new controller it might not be case normally.you can just connect it with some programmer board then try to erase flash and see it was detected by the programmer.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top