hi!!
i want to design a temperature sensor using LM35 and PIC24FJ256GB108(or any 16-bit PIC) and display the result on LCD. how do i go abt it. can anybody help with the circuit diagram?
what is the temp range you want to measure. Please look in the datasheet for the circuit diagram of the LM35. Then you should think of the interface method because guess the pic can only take 3.3V input.
i believe u shud have an idea of what u want. how to interface to the 16 bit PIC micro. try and do a sketch of your circuit diagram and then we can now where to proceed. check datasheet of the micro. definitely you are gong to use the adc module on the micro. lm35 is a straight forward device in terms of cnnection if u are able to read tru the datasheet.
hi,
it's simple. please refer LM35 data sheet. in that there is one connection diagram. by using that connect LM35 output to your controller any one of the ADC input. If LM35 input voltage=5V means output 0.1V= 1 degree Celsius(Aprox).
check out this site may be you could have a go from there.
**broken link removed**
you can also explore the tutrials on this site but the programming language used here is protonbasic . thats what i used its easy to understand. it depends on you