T610 Hyperterminal got error

[samkol649]

hyperterminal unreadable

Hi all,

I am trying to use hyperterminal to send AT command to my sony ericsson T610 phone. The settings are: 115200, 8, none, 1, none. The other baut rate gave me strange characters (unreadable characters). So, using the rate of 115200, my phone keeps on sending me weird reply. It just keeps on dumping characters onto the hyperterminal screen (never stop dumping)
I have tried perform the Master Reset, but it did not help.
I heard that many people have managed to send AT command to this phone via hyperterminal. Can anyone of you show me the steps to do so?

Best Regards,
Sam

Below are the the characters that the phone dumps onto the terminal:
************************************************************
MMM GPRS_SysInfo NOM_II
MMM HandleNOM: NOM_UNKNOWN->NOM_II, MS_Mode=1, ForcedFlag=2
GMM<-GMM_SYSTEM_INFO_IND
MPH B 723 0 0 0 0 3 5
si2t:010603DE4056B24000000000000000000000002B2B2B2B
MPH B 723 0 0 0 0 27 6
si3:49061B217703022707D0C003281B60437D00008000400B
MPH B 723 0 0 0 0 28 7
si4:31061C03022707D060437D00008000432B2B2B2B2B2B2B
MPH B 723 0 0 0 0 25 0
si1:5506198F6CAAAAA800000000000000000000007D00006B+
MPH B 723 0 0 0 0 26 1
si2:59061A9B19011B0BEFA10E8FFF6208D4E00000FF7D0000
MPH B 723 0 0 0 0 7 4
si15:050607804025081A4905CE1C747F150378F05D0B578619
MPH B 723 0 0 0 0 3 5
si2t:010603DE4056B24000000000000000000000002B2B2B2B
***************************************************************

 

[bobcat1]

Hi

Change the baud rate to lower speed

All the best

Bobi

 

[samkol649]

Thank you, Bobi for your reply. I tried changing the rate to slower speed, but what I got was strange characters (something that you cannot read). Only 115200 rate gives me something readable. Do I need to install any driver for the serial cable?
Any other ideas?

Again, thank you for your kind reply,
Sam