Switch from analloglib Cadence

Status
Not open for further replies.
A

antlhem

Member level 1
Joined
Dec 8, 2016
Messages
41
Helped
0
Reputation
0
Reaction score
0
Trophy points
6
Activity points
364
Hi, I am using the switch from analoglib in Cadence. But, seems to behave wrongly, any suggestions on how to configure the switch to output the signal only when the control is activated?
Attached you can see my circuit and the results


Only when the control signal is activated the output should show if the switch behaves correctly



Switch configuration
 

Sort by date Sort by votes
Everything behave correctly. 1T is not infinity, so as long as you are looking on unterminated swith you see its input no matter switch is on or off. Add at least load cap there.
 

Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…