Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronic Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Substrate Definition (size) for fabrication in ADS momentum

Status
Not open for further replies.

Behzadzahid

Newbie level 5
Joined
Dec 10, 2010
Messages
9
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,338
We have designed patch antenna in ADS momentum. When we went to manufacturer, to manufactured it, he asked us to give him 'gerber file' . We created the gerber file of our design but now manufacturer is asking to give me file with definite size of substrate. As in momentum the size of substrate is infinite so how can we define size of substrate in ADS momentum.
 

V

volker_muehlhaus

Guest
In Momentum, the size of the substrate is infinite. Always.

The size of the bottom ground is also infinite if you use the //// GND //// ground boundary condition. If you want to simulate with a finite ground, you can draw that and map it in the EM layer stackup and then use FreeSpace boundary above and below. But for patch antennas that should not make much difference, as long as the ground is "big enough".
 

Status
Not open for further replies.
Toggle Sidebar

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top