LeoStar
Member level 2
First it starts moving in the ACW and completes two rotations that is it goes twice in ACW completing FORWARD group of instructions in the code and then it comes back completing two lapses of BACKWARD set of instructions as in the code.
Then when it has to go in ACW again, it is somewhere around this time when the jerks start making the motor move back and forth in both the directions taking one or two steps each.
- - - Updated - - -
It should work continuosly like this but it doesn't. Is this a common problem with stepper motors?
- - - Updated - - -
I tried it again. It worked correctly two times i.e. worked according to the program twice and then it went into its random nature again,
Help is duly needed.
- - - Updated - - -
Is anyone there?
Then when it has to go in ACW again, it is somewhere around this time when the jerks start making the motor move back and forth in both the directions taking one or two steps each.
- - - Updated - - -
It should work continuosly like this but it doesn't. Is this a common problem with stepper motors?
- - - Updated - - -
I tried it again. It worked correctly two times i.e. worked according to the program twice and then it went into its random nature again,
Help is duly needed.
- - - Updated - - -
Is anyone there?