Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Stability widlar bandgap reference

Status
Not open for further replies.

jc2

Member level 3
Member level 3
Joined
Mar 5, 2005
Messages
64
Helped
3
Reputation
6
Reaction score
1
Trophy points
1,288
Activity points
1,793
I designed a bandgap reference source. I will put an output capacitor for improving the noise specification, but the bandgap reference output presents oscilations in the transient simulations. It is the most simple bandgap reference source, this does not use an OPAMP. How could I improve the stability of the circuit?? could I measure the margin phase?? where should I cut the loop??

Thank you
 

Please show us your schematic? You can break the loop at the output gain stage.
 
  • Like
Reactions: jc2

    jc2

    Points: 2
    Helpful Answer Positive Rating
widlar1.jpg

This is the circuit.
 

It is an output capacitor of 12uF.
 

It is expected that it will oscillate, as the cap will introduce a negative phase shift to the loop response.
Besides, that is not the classical widlar bandgap.
You need the circuit, just google for it.
 

You need to apply ac signal to Gate of Q2 by braking gate bias. You must be knowing that there are two poles existing the the closed loop, if they are close to each other, And again there are existing two feedback.One Negative feedback (combination of Vbe2 and R1 and positive feedback is upper loop .
If your positive feedback is dominating to negative you circuit will oscillate. You have to either increase the effect of R1 or decrease the close loop positive feedback gain. Hope this will help.
 
  • Like
Reactions: jc2

    jc2

    Points: 2
    Helpful Answer Positive Rating
Hi,
I agree. But isnt it, due to the cap added, the frequency dependent phase shift will occur at a lower frequency, there by inverting the characteristics of the +ve loop. So, before UGB, we can get 2 possible -ve feedback. And increasing R1 will results in increasing the negative f/b magnitude, but will it try to alter the feedback characterisitcs? Please correct me if I;m wrong?
 
  • Like
Reactions: jc2

    jc2

    Points: 2
    Helpful Answer Positive Rating
there by inverting the characteristics of the +ve loop.
Why it will happen?
before UGB, we can get 2 possible -ve feedback.
I see only one negative feedback.
And increasing R1 will results in increasing the negative f/b magnitude, but will it try to alter the feedback characterisitcs?
Yes it affects the positive loop current gain. R1 also acts as degeneration resistance. Any variation due to positive loop gain get cancelled and output current depends on voltage across R1.
 
  • Like
Reactions: jc2

    jc2

    Points: 2
    Helpful Answer Positive Rating
Due to 12uF cap, the pole will occur very well at a lower frequency, there by giving a 90 degree phase shift to the Postive feedback, given by Q1, Q2, M1 & M2. So, this phase shifted +ve loop & the original negative feedback, given by the source degenearation resistance combinedley can have 2 -ve loop before UGB.(As the source degeneration will not be affected by the cap).
 
  • Like
Reactions: jc2

    jc2

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top