rayhh27
Member level 1
Hi,
I am intending on using SPI on MAX10, my question is,
1. Is it okay to connect the MISO, MOSI, CS_N on the normal I/O pins on max10?
2. The speed of the SCK is 5.5Mhz is it actually necessary to connect it to PLL out or a normal IO or even a PLL in will work just fine?
Thank you for your precious time.
Best regards,
RH
I am intending on using SPI on MAX10, my question is,
1. Is it okay to connect the MISO, MOSI, CS_N on the normal I/O pins on max10?
2. The speed of the SCK is 5.5Mhz is it actually necessary to connect it to PLL out or a normal IO or even a PLL in will work just fine?
Thank you for your precious time.
Best regards,
RH