Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
You might use the maximum humidity and temperature specs for the card and set that up in a environmental chamber. If you have the capability to do so, you can add salt-fog to the environment.
You could try stuffing the sim into a ballon carefully and then take it to a welder and get them to inflate the ballon with oxygen from a gas weld set, then tie a knot in it and leave it a week or so.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
