Tetra
Junior Member level 1
xil_map_locwarn
The problem summrized in the following steps
1- I need to assign certain pins pf spartan 2 device so I used different methode to do so (Constrains editor, ucf file gnerated from leonardo, attribute in VHDL file ) all methode gave successful results and the Constraint Editor see the assignments of pins in the required positiones.
2- The MAP step in design manager gave the following error in almost all the assigned pin
"ERROR:MapLib:30 - Bad format for LOC constraint 129 on IBUF. To bypass this
error set the environment variable 'XIL_MAP_LOCWARN'."
3- I did the setting of the required environment variable and the all design flow had been pass successfuly.
4- I reviewed the output report of "PAD report" and I found that the assigned pin location differ greatly from that seen in the constrains editor.
can any one help.
The problem summrized in the following steps
1- I need to assign certain pins pf spartan 2 device so I used different methode to do so (Constrains editor, ucf file gnerated from leonardo, attribute in VHDL file ) all methode gave successful results and the Constraint Editor see the assignments of pins in the required positiones.
2- The MAP step in design manager gave the following error in almost all the assigned pin
"ERROR:MapLib:30 - Bad format for LOC constraint 129 on IBUF. To bypass this
error set the environment variable 'XIL_MAP_LOCWARN'."
3- I did the setting of the required environment variable and the all design flow had been pass successfuly.
4- I reviewed the output report of "PAD report" and I found that the assigned pin location differ greatly from that seen in the constrains editor.
can any one help.