MahmoudHassan
Full Member level 6
this question is from Razavi Design on analog cmos integrated circuit ed 2 chapter 3 3-16 (c)
it is required to sketch vout vs vin for the circuit in the left --- the solution shown in the right (in the captured picture for the solution manual)
i think in the answer there is an error as R1 and R2 swapped ?
my answer showed in the picture captured using red pen
my answer vout = VDD- (1+ R1/R2)vth2
for vin= vth1 + (2*VTH2 /( kn *R2 * (w/l)1 ))*.5
i hope to help me about this ...and if iam not correct can you show me how you get this answer
(This is not a home work ...sure )
it is required to sketch vout vs vin for the circuit in the left --- the solution shown in the right (in the captured picture for the solution manual)
i think in the answer there is an error as R1 and R2 swapped ?
my answer showed in the picture captured using red pen
my answer vout = VDD- (1+ R1/R2)vth2
for vin= vth1 + (2*VTH2 /( kn *R2 * (w/l)1 ))*.5
i hope to help me about this ...and if iam not correct can you show me how you get this answer
(This is not a home work ...sure )