BOXBOX
Newbie level 4
Hi there..
I am currently working on a project, to design a Electronic Driver for Electroluminescent (EL) Lamp.
The EL Lamp needs to be driven by a sine waveform of 135Vrms (approx 200Vpeak) @ a frequency of 1300Hz. On the whole, the driver itself, should be powered by DC supply (Batteries).
So far, i've looked into PWM & buck boost circuit, but don't seems to be getting the desired results.
So i hope to seek advices & comments from u guys here at EDA Board..
Hope to hear from u guys soon..
Thank you & regards..
I am currently working on a project, to design a Electronic Driver for Electroluminescent (EL) Lamp.
The EL Lamp needs to be driven by a sine waveform of 135Vrms (approx 200Vpeak) @ a frequency of 1300Hz. On the whole, the driver itself, should be powered by DC supply (Batteries).
So far, i've looked into PWM & buck boost circuit, but don't seems to be getting the desired results.
So i hope to seek advices & comments from u guys here at EDA Board..
Hope to hear from u guys soon..
Thank you & regards..