Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronic Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Simm 300 probllem with call ready

Status
Not open for further replies.

ivan.ruotolo

Newbie level 1
Joined
Jul 7, 2009
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
caserta
Activity points
1,288
GOOD DAY TO ALL AND THANKS FOR YOUR SUPPORT, YOU ARE VERY IMPORTANT
have a problem with a GSM modem I use it through a program written by me in vb.net, I have the following problem,
through the hyper terminal program I was given every 2 minutes the written call ready, how can I delete this?
and then I have trouble connecting with my carrier, but the signal and 90.90 ..
how can I do?
Thank you very much
 

ckshivaram

Advanced Member level 5
Joined
Apr 21, 2008
Messages
5,070
Helped
2,146
Reputation
4,298
Reaction score
2,087
Trophy points
1,393
Location
villingen (Germany) / Bangalore
Activity points
30,097
at+csq =90,90 is unsolicicated. that means no or very less signal. RSSI level is too less. connect antenna properly and try.

If you have stored any data in modem flsh and want to erase then give command AT&F and enter

then AT&W enter. this will take modem to default factory settings. later you can configure it again
 

Status
Not open for further replies.
Toggle Sidebar

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top