dl09
Full Member level 4
i bought 2 4 millimeter by 8 millimeter electric motors from china. they stopped working. i connected them to the 3.3 volt
pin of an arduino uno. initially they worked when connected to the 3.3 volt pin of an arduino uno .
did they stop working because of current overload?
here is a schematic. i use my laptop to power the arduino uno, which powers the electric motor.
would connecting the motor to a resistor, prevent this problem?
pin of an arduino uno. initially they worked when connected to the 3.3 volt pin of an arduino uno .
did they stop working because of current overload?
--- Updated ---
here is a schematic. i use my laptop to power the arduino uno, which powers the electric motor.
--- Updated ---
would connecting the motor to a resistor, prevent this problem?
Last edited by a moderator: