yardum
Newbie level 5
I have followed the guide here
however I'm getting many errors like this one:
Please could you describe how to setup corners for this kit.
seems to run if nominal corner is deselected. not sure why the option is there if it messes things up.
however I'm getting many errors like this one:
Code:
Error found by spectre during circuit read-in.
ERROR (SFE-59): "/Cadence/gpdk045_v_5_0/models/spectre/gpdk045_mos.scs" 230: Cannot run the simulation because parameter →xn′hasalreadybeendef∈ed.Toallowduplicateparameterdef∈itions,setthevalueof
' role="presentation">→xn'hasalreadybeendef∈ed.Toallowduplicateparameterdef∈itions,setthevalueof→xn′hasalreadybeendef∈ed.Toallowduplicateparameterdef∈itions,setthevalueofredefinedparams' to ignore′or' role="presentation">ignore'orignore′orwarning' in the netlist to consider the parameter defined later. Next, rerun the simulation.Please could you describe how to setup corners for this kit.
--- Updated ---
seems to run if nominal corner is deselected. not sure why the option is there if it messes things up.
Last edited: