majkl85
Newbie level 3
Hello,
I wonder if there's any way to save only the diffusion component of the drain current in .plt file? I tried to figure it out from the manual, but it seems like there is no direct solution for that. Does anyone have an idea, how to write a simulation command file to obtain the results that will neglect the drift component?
Best regards,
Michal
I wonder if there's any way to save only the diffusion component of the drain current in .plt file? I tried to figure it out from the manual, but it seems like there is no direct solution for that. Does anyone have an idea, how to write a simulation command file to obtain the results that will neglect the drift component?
Best regards,
Michal