Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Sentaurus Device - separating drift and diffusion currents

Status
Not open for further replies.
M

majkl85

Newbie level 3
Joined
May 6, 2010
Messages
4
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,283
Location
Poland
Activity points
1,306
Hello,

I wonder if there's any way to save only the diffusion component of the drain current in .plt file? I tried to figure it out from the manual, but it seems like there is no direct solution for that. Does anyone have an idea, how to write a simulation command file to obtain the results that will neglect the drift component?

Best regards,
Michal
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top