debugtimog
Newbie level 5
Hi,
I have a sensor board that measure flow by detecting the float level. The float is made up of magnet and so I am suspecting that the sensor if hall effect. The reading is intermittent on the display.
Top
Bottom
1. I would like to remove the copper like shield (see red rectangle) so that I can see the marking. But after knowing the correct sensor part number and install back the shield, will the sensing accuracy performance be affected? WHat is the purpose of that shield?
2. Please help me identify what is the sensor or link I can start my search.
I have a sensor board that measure flow by detecting the float level. The float is made up of magnet and so I am suspecting that the sensor if hall effect. The reading is intermittent on the display.
Top
Bottom
1. I would like to remove the copper like shield (see red rectangle) so that I can see the marking. But after knowing the correct sensor part number and install back the shield, will the sensing accuracy performance be affected? WHat is the purpose of that shield?
2. Please help me identify what is the sensor or link I can start my search.