Yusif_Nurizade
Newbie level 1
Hello,
I am trying to import an OrCAD file (.DSN) into Altium. I was able to import an earlier version of the file using the Import Wizard without issue. When I try to import the update version, I am able to go through the Import Wizard steps and a project is created. When I open up the schematic, however, the components are scattered about with broken connections and no names.
I tried importing as an OrCAD file and OrCad file with PADS as well as saving for different version in OrCAD but keep getting the same problem. I even went back and re-imported the original to see if there was something wrong with my Altium settings but it came out fine. I also did an online search but did not have any success although I must admit I had a hard time picking the right words for a Google search.
Has anyone here had a similar problem? Please advise.
Best,
Yusif Nurizade
I am trying to import an OrCAD file (.DSN) into Altium. I was able to import an earlier version of the file using the Import Wizard without issue. When I try to import the update version, I am able to go through the Import Wizard steps and a project is created. When I open up the schematic, however, the components are scattered about with broken connections and no names.
I tried importing as an OrCAD file and OrCad file with PADS as well as saving for different version in OrCAD but keep getting the same problem. I even went back and re-imported the original to see if there was something wrong with my Altium settings but it came out fine. I also did an online search but did not have any success although I must admit I had a hard time picking the right words for a Google search.
Has anyone here had a similar problem? Please advise.
Best,
Yusif Nurizade