Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

SAW filter design 101

Status
Not open for further replies.

skpgreen25

Newbie level 3
Joined
Jul 1, 2009
Messages
3
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
Chennai, India
Activity points
1,298
Hi,

I'm a newbie and this could be a stupid question.

I am keen on learning to "design" a SAW filter. I understand it involves simulating acoustic waves, but I am interested in knowing the steps in designing a SAW filter. Can it be not simulated at all?

What are the options and alternatives?


Thanks again!
 

Thanks for your reply Sunny.

My interests in designing SAW filters are purely academic hence no 'specific' requirements per se.
But for general specifications:

LPF at 0.5GHz, matched to 50 Ohm impedance lines.
Noise figure, order (if applicable) can be anything, since its for the purpose of learning.

Thanks.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top