Terminator3
Advanced Member level 3
For example:
**broken link removed**
Reference plane is placed at 1.3mm from device center (at 2.6mm diameter, where leads just touched the substrate).
But also there are substrate parameters given:
Substrate used is t=0.254 mm + many vias to ground on source pins.
All those vias (inductance), is it included in S-parameters?
**broken link removed**
Reference plane is placed at 1.3mm from device center (at 2.6mm diameter, where leads just touched the substrate).
But also there are substrate parameters given:
Substrate used is t=0.254 mm + many vias to ground on source pins.
All those vias (inductance), is it included in S-parameters?