needtoknow
Newbie level 2
sparameter change of impedance
I have a s2p data for 50 Ohm system.
In this link (page 13), there are equations defined to change the s2p data from Zo to Zop (new Zo value).
cpd.ogi.edu/IEEE-MTT-ED/S-Parameter%20Basics.pdf
Anyone knows the equations used to change the s2p data if I am using different source/ load impedance? For an example, source impedance remains 50Ohm but load impedance changed to 75Ohm.
I know that the simulation tools such as ADS and etc. can do the calculations for me but I am curious to know the equations to be used.
I have a s2p data for 50 Ohm system.
In this link (page 13), there are equations defined to change the s2p data from Zo to Zop (new Zo value).
cpd.ogi.edu/IEEE-MTT-ED/S-Parameter%20Basics.pdf
Anyone knows the equations used to change the s2p data if I am using different source/ load impedance? For an example, source impedance remains 50Ohm but load impedance changed to 75Ohm.
I know that the simulation tools such as ADS and etc. can do the calculations for me but I am curious to know the equations to be used.