Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronic Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

s parameter problem on cst 2010

Status
Not open for further replies.

Satyajit Banerjee

Newbie level 1
Joined
Aug 4, 2015
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
8
everytime i changes frequency range, s1,1 curve also change......
why this is so??? tjis create problem in getting the exact result....
 

nvt088

Member level 5
Joined
Dec 24, 2013
Messages
81
Helped
10
Reputation
20
Reaction score
10
Trophy points
8
Location
Jupiter
Activity points
521
What is your center frequency?
How about fixing center frequency in your setup? I think that CST will use the center frequency for meshing. Therefore, if you change it, the result will change a little bit.
For example, your frequency range is 100 - 300 MHz. The center frequency is 200MHz.
So, just change the frequency range like 50 - 350 MHz, and so on.
 

gemmy94

Junior Member level 3
Joined
Apr 13, 2015
Messages
28
Helped
2
Reputation
4
Reaction score
2
Trophy points
3
Activity points
242
everytime i changes frequency range, s1,1 curve also change......
why this is so??? tjis create problem in getting the exact result....
That error may be due to the step you choose between each run. Example
First run: 1GHz - 3GHz with step 1000 but after that it is rechanged step to 500.
 
  • Like
Reactions: nvt088

    nvt088

    points: 2
    Helpful Answer Positive Rating

hamidrezakarami

Full Member level 3
Joined
Feb 26, 2007
Messages
181
Helped
45
Reputation
88
Reaction score
42
Trophy points
1,308
Activity points
2,151
That error may be due to the step you choose between each run. Example
First run: 1GHz - 3GHz with step 1000 but after that it is rechanged step to 500.
Changing the frequency of simulation leads to new mesh-cells for your structure, so your results can be changed!!!
 
Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top