Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Running a specific limited DRC in eagle pro?

Status
Not open for further replies.
T

treez

Guest
Hello,

I wish to run a DRC on the PCB but just only to check for distance from copper to edge of board.

How do i do this alone?
 

keith1200rs

Super Moderator
Staff member
Joined
Oct 9, 2009
Messages
10,877
Helped
2,065
Reputation
4,130
Reaction score
1,597
Trophy points
1,403
Location
Yorkshire, UK
Activity points
57,269
Other than creating a DRC file with really small (or large) limits for everything else, I think you could possibly do it by writing a ULP. I would simply run the DRC and scroll down to look for the "DIMENSION" errors.

Keith.
 
  • Like
Reactions: treez

    T

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top