Routing error with ares

Status
Not open for further replies.
D

didiersee

Newbie level 1
Joined
Jun 19, 2017
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
15
Hello everyone, I realized a small printed circuit with the ARES software from PROTEUS. The worry is a mistake that persists despite that I routed via a wired bridging. On the attached image you can see the white link (error) and the wired bridge that is nevertheless well connected. Does anyone know how to solve this problem?
NB: I am on PROTEUS 8.1 (ENGLISH)
Thanks in advance
 

Hi, Check the properties of red colored track connection between the vias. It may be in non-electrical one.
 


post your schamatic.
and there is no need to create a vias.
the transistor pin 1 can be routed from below the resistor R1. and pin 3 of U1 can directly be connected to R1.
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…